PDFPrintE-mail


SRF02 - Low Cost, Ultrasonic Ranger 16cm to 6m
View Full-Size Image


SRF02 - Low Cost, Ultrasonic Ranger 16cm to 6m

( Devantech )
SG$23.90


Lowest cost ultrasonic ranger with both I2C and Serial interfaces. New AutoTune algorithms intelligently back the minimum range right up to the transducer ringdown for the very best performance possible, automatically, in the background, and with no calibration cycles necessary. Additional new commands allow for separate burst and ranging control.


SRF02
Range - 16cm to 6m.
Power - 5v, 4mA Typ.
Frequency - 40KHz.
Size - 24mm x 20mm x 17mm height.
Analogue Gain - Automatic 64 step gain control


Connection Modes
1 - Standard I2C Bus.
2 - Serial Bus - connects up to 16 devices to any uP or UART serial port
Full Automatic Tuning - No calibration, just power up and go
Timing - Fully timed echo, freeing host controller of task.
Units - Range reported in uS, mm or inches.
Light Weight - 4.6gm

Overview
The SRF02 is a single transducer ultrasonic rangefinder in a small footprint PCB. It features both I2C and a Serial interfaces. The serial interface is a standard TTL level UART format at 9600 baud,1 start, 2 stop and no parity bits, and may be connected directly to the serial ports on any microcontroller. Up to 16 SRF02's may be connected together on a single bus, either I2C or Serial. New commands in the SRF02 include the ability to send an ultrasonic burst on its own without a reception cycle, and the ability to perform a reception cycle without the preceding burst. This has been as requested feature on our sonar's and the SRF02 is the first to see its implementation. Because the SRF02 uses a single transducer for both transmission and reception, the minimum range is higher than our other dual transducer rangers. The minimum measurement range varies from around 17-18cm (7 inches) on a warm day down to around 15-16cm (6 inches) on a cool day. Like all our rangefinders, the SRF02 can measure in uS, cm or inches.

Operating Modes
There are two operating modes for the SRF02. I2C mode and Serial Mode. This is set with the Mode pin, connected to 0v Ground for Serial Mode and left unconnected (or tied to +5v Vcc) for I2C Mode.

**  Full Technical Data


 

 


Availability

In Stock: 2

Usually ships in:

2-3d.gif


Customer Reviews:

There are yet no reviews for this product.
Please log in to write a review.





Shopping Cart

Your Cart is currently empty.

Product Search



Advanced Search

HTTPS Secure

Currency Selector