PDFPrint

Sound & Voice feed

Sort by:
12mm x 9.5mm active buzzer 5V

12mm x 9.5mm active buzzer 5V


SG$0.80
12mm x 9.5mm active buzzer 5V [Product Details...]
PmodAMP2 - Audio amplifier

PmodAMP2 - Audio amplifier


SG$19.90
The PmodAMP2 amplifies low power audio signals to drive a monophonic output. The module features a digital gain select that allows output at 6 dB and 12 dB with pop-and-click suppression. A Digilent 6-pin connector provides the audio input to the module a [Product Details...]

9mm Electromagnetic Buzzer: 40Ω, 4-6V, Top Opening

9mm Electromagnetic Buzzer: 40Ω, 4-6V, Top Opening


SG$2.50
This electromagnetic transducer is a compact way to add sound to your embedded project: just supply it with a PWM signal at 4 V to 6 V and it will produce sound at the frequency of the supplied signal from an opening on the top. [Product Details...]
14mm x 4.0MM Small Enclosed Piezo

14mm x 4.0MM Small Enclosed Piezo


SG$7.00
14mm x 4.0MM Small Enclosed Piezo [Product Details...]

Passive Buzzer

Passive Buzzer


SG$0.90
This passive buzzer is a compact way to add sound to your embedded project: just supply it with a PWM signal at 4 V to 6 V and it will produce sound at the frequency of the supplied signal from an opening on the top. [Product Details...]
Thin Plastic Speaker w/Wires - 8 ohm 0.25W

Thin Plastic Speaker w/Wires - 8 ohm 0.25W


SG$1.50
This 1.5" diameter speaker cone is the perfect addition to any audio project where you need an 8Ω impedance and are using 0.25W of power. The speakers are rated at 0.25W, with a maximum input of 0.5W (printed wattage on back of speaker may have either val [Product Details...]

Sound/Voice Synthesizer -  Speak Jet Activity Center

Sound/Voice Synthesizer - Speak Jet Activity Center


SG$99.00
Development board for experimenting and developing applications around the SpeakJet™. Exploits all of the SpeakJet™ capabilities. [Product Details...]
ISD1820 Voice recorder and play back Module With Mic and Speaker

ISD1820 Voice recorder and play back Module With Mic and Speaker


SG$4.50
This voice Record Module is base on ISD1820, capable of multiple‐message record/playback.It can offers true single‐chip voice recording, no‐volatile storage, and playback capability of about 10 seconds. [Product Details...]

Voice Recorder Breakout - ISD1932

Voice Recorder Breakout - ISD1932


SG$17.50
This is a breakout board for the ISD1932, a multiple-message record/playback device. This single chip can record up to 64 seconds worth of voice messages. Microphone inputs and speaker outputs are all handled by the ISD1932. [Product Details...]
Audio Amplifier 3W PAM840

Audio Amplifier 3W PAM840


SG$7.70
This is a mini stereo amplifier. It is a fully functional, two-channel audio amplifier, comes with electronic switcher. [Product Details...]

Audio Analyzer

Audio Analyzer


SG$27.50
This module features the MSGEQ7 graphic equalizer display filter.It will give your arduino ears. Sound is broken down into seven frequency bands and the peak level for each band can be read. The seven frequencies measured are as follows: 63Hz, 160Hz, 400H [Product Details...]
Surface Transducer - Small

Surface Transducer - Small


SG$15.70
Surface transducers give you the awesome power to turn almost any surface into a speaker. Much like our larger surface transducer, this is essentially just a speaker except instead of a cone, the coil is attached to a pad that conducts the vibration into [Product Details...]

DIP Sockets Solder Tail - 28-Pin

DIP Sockets Solder Tail - 28-Pin


SG$0.20
Dip sockets for all your prototyping needs. If you’ve ever had to de-solder a dip part from a circuit board, you know how valuable these are! [Product Details...]
Text to Speech chip for SpeakJet - TTS256

Text to Speech chip for SpeakJet - TTS256


SG$33.50
The TTS256 is an 8-bit microprocessor programmed with letter-to-sound rules. This built-in algorithm allows for the automatic real-time translation of English ASCII characters into allophone addresses compatible with the Magnevation SpeakJet Speech Synthe [Product Details...]

VoiceBox Shield

VoiceBox Shield


SG$57.00
The VoiceBox Shield can be mounted on top of your Arduino board to give it access to all of the capabilities of the SpeakJet voice and sound synthesizer. The Voice Box Shield uses the SpeakJet chip to convert serial commands into a great robot-sounding vo [Product Details...]
DFPlayer Mini MP3 Player Module For Arduino

DFPlayer Mini MP3 Player Module For Arduino


SG$6.70
The DFPlayer Mini is a small and low cost MP3 module with an simplified output directly to the speaker. The module can be used as a stand alone module with attached battery, speaker and push buttons or used in combination with an Arduino UNO or any other [Product Details...]

Audio-Sound Breakout - WTV020SD

Audio-Sound Breakout - WTV020SD


SG$27.00
The WTV020SD is a small, simple IC for embedding audio-playback into your next project. These devices are commonly used in children's toys and "talking" retail displays. This breakout board allows you to access the functionality of the WTV020SD to give a [Product Details...]
LilyPad Buzzer

LilyPad Buzzer


SG$10.20
This is a small buzzer for the LilyPad system. Use 2 I/O pins on the LilyPad main board and create different noises based on the different frequency of I/O toggling. Loud enough to hear inside a pocket but not obtrusively loud. [Product Details...]

Audio Jack Breakout

Audio Jack Breakout


SG$1.50
Simple breakout board for the 3.5mm audio jack. Use this breakout (shipped bare) to allow breadboard or SIP access to the super-common 3.5mm audio jack. All five pins are broken out. [Product Details...]
Audio Jack 3.5mm

Audio Jack 3.5mm


SG$1.90
Low profile 3.5mm stereo audio jack. [Product Details...]




Display #  
Results 1 - 20 of 22

Products Categories

We Accept


 


Shopping Cart

Your Cart is currently empty.

NOTE..


-> NO GST -> NO GST -> NO GST

Product Search



Advanced Search

Currency Selector




HTTPS Secure